Home
Up

METALIC FORMWORK

 

METALIC FORMWORK

 

        These metallic formwork plates are indistinctly suitables for pillars and walls. They can be set up horizontally as well as vertically, this allows a big saving in labour, due to the fast assembling and their recovery, versatility and durability.

 

       

            1                                                            2

1.    Four plate assembly for pillars, no accesories needed.

2.    Two sided wall metallic planking detail, adjustable lead screw..  

The metal sheets are 2mm. thick, and have the following sizes:

2.50 x 0.50 m. 1.25 x 0.50 m.
3.00 x 0.50 m. 2.60 x 0.50 m.

        Pillars can be built from 0.25 up to 0.45m. width with intervals of 5cm. For bigger measurements plate unions is necesary.

 

        Wall with horizontal plates and vertical beams.

 

        These shuttering plates are useful for making concrete columns in a modular way, section can vary every 5 cm. The shutering panels are manufactered with special steel thickness of 2 mm., having three to hour reinforcements and robotized welding. 

        There are two main models; with four sides welded or with two sides bend and two welded. There is also the possibility of combining two measurements of different plates in order to make pillars or rectangular concrete columns.

                       

        There use is easy  and fast, the starting or beginning basis are placed on the floor and the conjoint of plates on them. The joints in the top corners of the column are made through the corner plate.

  1. Central reinforcement

  2. Hols base

  3. Bending side with holes for lateral joint.

  4. 10 pivots

The construction of small concrete walls (channelles, ditches, etc) 

  • With folding plates, Plates PL2 mooring is used.

  • With welded plates, Look F-10 is used.

  • The separation among the different plates is made by means of the punched metal strip,  cutting it to measure. 

                       

  1. Starting or begining basis

  2. Corner plate

  3. Mooring

  4. Look

The sizes:

NORMAL

MODEL PL-2

FOUR PARTS WELDED SHEETS WITH 2 FOLDED PARTS AND 2 WELDED PARTS 

THICKNESS OF SHEET 2mm

THICKNESS OF SHEET 2mm
50 x 50 cm  25 x 50 cm
60 x 50 cm (12pi.) 30 x 50 cm
70 x 50 cm (14pi.) 35 x 50 cm
80 x 50 cm (16pi.) 40 x 50 cm
100 x 50 cm (20pi.) 45 x 50 cm
50 x 100 cm (10pi.) 50 x 50 cm
  60 X 50 cm
  50 X 100 cm
 

For more information or catalogues please contact us.

 

ANTÓNIO & JOÃO and the logo are registered trademarks of ANTÓNIO & JOÃO, LDA